46
VF Series control module
SAVE/CLEAR
RUN/STOP
SETUP/RETURN
FORWARD
BACK
+
Figure 8-1_Control Panel - Operator Interface
Use the control panel (FIG. 8-1) to set temperatures, operating conditions, and monitor appliance operation.
8
Operating information
Access modes
User
The user can adjust the space heating target
temperature and the tank target temperature
(if a tank sensor is used) by using the (+)
and (-) buttons (FIG. 8-1) at any time
during normal operation. By entering the
USER code (0704), the user can also change
temperature units, time and date, and night
setback settings. In User Mode, the following
parameters can be viewed but not changed:
• Appliance model number
• Software version
• Total operating hours
• Total cycles
Installer
Most parameters are available only to the
installer, accessible only by entering the
installer access code, see the VF Series Service
Manual.
Saving parameters
(reference the
Parameter Table in the VF Series Service
Manual)
To save parameters and exit programming:
Press the SAVE/CLEAR button, then the
SETUP/RETURN button 3 times.
To keep parameter settings only for a current
operating cycle:
Press the SETUP/RETURN button 3 times
after making all desired parameter changes.
To enter a parameter and continue
programming:
Press the SETUP/RETURN button 1 time to
return to the parameter listings; press again
to return to the menu listings. Remember to
press the SAVE/CLEAR button when finished
programming in order to save the changes
made.
See the VF Series Service Manual for a detailed
description of parameters and access modes.
Installation & Operation Manual
