Network Video Recorder Quick Start Guide
17
2.3.3 Using Alarm Connectors
To connect alarm devices to the NVR:
1.
Disconnect
pluggable block
from the ALARM IN /ALARM OUT terminal block.
2.
Unfasten stop screws from the
pluggable block
, insert signal cables into slots and fasten stop
screws. Ensure signal cables are tight.
3.
Connect
pluggable block
back into terminal block.
2.3.4 Controller Connection
Figure 2. 15 Controller Connection
To connect a controller to the NVR:
1.
Disconnect pluggable block from the KB terminal block.
2.
Unfasten stop screws from the KB D+, D-
pluggable block
, insert signal cables into slots and
fasten stop screws. Ensure signal cables are in tight.
3.
Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block.
Fasten stop screws.
4.
Connect
pluggable block
back into terminal block.
Make sure both the controller and NVR are grounded.
