WIRELESS MODEL INSTALLATION
SPEED TRANSMITTER & MAGNET
The V100 is designed to operate as a wireless unit with the
installation of a special active mount and WL wireless speed
transmitter.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Use the zip-ties supplied to hold loosely the WL wireless
speed transmitter and mounting pad to the left fork leg.
Note:
To maximize signal reception, position the
transmitter as high up on the fork leg as possible. (Fig.
9)
Tighten the spoke magnet to any spoke on the
"transmitter side" of the front wheel so that it passes
over the alignment mark on the transmitter. (Fig. 9, 10)
Attach the alignment setup spacer to the magnet
temporarily. (Fig. 11 )
Slide and rotate the transmitter until the alignment mark
just touches the spacer tip on the magnet. (Fig. 12)
Snug the zip ties down to hold the transmitter in its final
position.
Remove the spacer and verify that the magnet and
NOTE:
WL2X Double wireless Speed & Cadence is optional.
Please refer to WIRED SPEED AND CADENCE/WL2X DOUBLE
Содержание V100
Страница 29: ...Fig 1 Fig 2 Wired Speed Sensor Fork Leg Spoke Magnet Spoke Magnet Spoke Magnet Sweep Path Zip Tie ...
Страница 30: ...Fig 4 Spacer Tip Alignment Mark Spacer Fig 3 Spoke Magnet Spoke Fig 5 Wired Speed Sensor Spoke Magnet ...
Страница 37: ...Head Unit Mounting Pad Handlebar Wireless Active Mount Zip Tie Fig 15 ...
