VETRON 5000, Руководство по обслуживанию

Страница: 65 / 118

5 mm
1
3
2
5
4
62
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
63
05/2019
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
03. ADJUSTMENT
26. KNIFE POSITION AND PRESSURE
DISPLAY STEP DESCRIPTION
» KNIFE POSITION AND PRESSURE
NOTICE:
The knife pressure needs to be adjusted depending on the thread in use. Adjusting the pressure too strongly leads to
premature wear and possible malfunction of the thread cutting device.
01
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
02 » Until chapter 26 appears on the display.
03
6
e
T
r r setup s s e
h ea n fe k d r i 2
p
u
» Confirm.
INFO:
The pedal is blocked. While
turning by hand the display shows the
machine position in degrees. Stitch
length is set to
0mm
.
04
Turn the machine with the mechanical hand wheel until the middle screw
5
of the hook grip
is at the front.
05
Loosen screw
4
, until the knife carrier
3
can swing.
06
Move the thread catcher
1
until the point
has a distance to the cutting edge of the knife
2
of 5mm.
07
In this position turn the knife carrier
3
until the cutting
edge of the knife
2
touches the catcher
1
.
08 Tighten screw
4
.
09 Check the cutting pressure according to the general rule.
10 » Confirm to proceed to the next step.
NOTE:
The knife pressure should only be strong enough for reliable thread cutting.