275 MARCUS BLVD, Suite J, HAUPPAUGE, NY 11788 USA
Tel: 631-434-3185 Fax: 631-434-3516
www.vetra.com email: [email protected]
c) DVI Monitor Connect the DVI monitor to the DVI-D connector on the backpanel of the Switch marked "MONITOR IN".
Or in the case of the D2, D3, and D4 series MegaSwitch
Connect the DVI Monitor A to the DVI-D connector on the back panel of the Switch marked "MONITOR-A IN". Repeat for
Monitors B, C, and D, as required.
d) Hub Support The Switch supports one level of hub at its USB Type A inputs, marked "IN-1" and “IN-2”. You have the
option to connect devices to the Switch directly or via a hub. You can connect a hub, either an external hub or one built into
a device, such as a keyboard, to either or both of the two USB Type A inputs. Devices can be connected either to a hub or
directly to the Switch. The total number of active devices is limited to two. If more than two devices are connected, the
additional devices will not be recognized by the Switch. In such a case, if the excess devices are unplugged, the remaining
two devices will become operational.
3. Connect the Power Supply to the Video Switch:
The Video Switch is powered by an external wall plug-in supply the VIP-210 (+5Vdc 1A reg. 110 - 240 Vac 50 - 60 Hz).
First plug the power output plug of this external supply into the mating jack on the backpanel of the Video Switch marked
"+5VDC IN", and only then plug the supply into a suitable AC power source. Since the Video Switch has no separate power
on/off switch, it is recommended that the power supply be connected to an AC power source that has a power on/off
switch.
OPERATION
1. Power Up Sequence:
Before making any connections to the PC's, connect the external power supply to the Power Jack of the Switch, marked
"+5VDC IN", on the back panel of the Switch. Keyboard, mouse and monitor(s) may be connected to the Switch at any
time.
2. PC Selection:
a) Keyboard "Hot Key" Selection (available on all models): To select an active PC, first hold down the Scroll Lock
Key, then press and release the top row keyboard keys 1 or 2. The number keys must be released before the Scroll
Lock key. Switching takes place on the release of the Scroll Lock Key, which also rearms the keyboard selection
mechanism. When selection of PC#1 or PC#2 is completed, observe on the front panel of the switch that the appropriate
green "SEL" indicator is on.
b) Selection from Front Panel:
1) Next PC (available on Standard models only): To select another PC, press the “NEXT PC” pushbutton
located on the front panel of the MegaSwitch.
2) Direct Entry (available on -DE models only): To select another PC, press the “PC SELECTION” pushbutton
for the appropriate PC desired.
