English
- 8 -
Turning the Display On/O
ff
Press the
Standby
button on the remote or on rear left side of the Display to switch it on from standby or to
switch it into standby mode.
V+
V-
Joyst�ck
LED Status
Status of the monitor
Power LED not lit
Power on
Power LED lit
Power off (Standby mode)
Power LED flashing (slow)
Scheduler active
Power LED flashing (fast)
Power up/down and software update
Connecting the IR Receiver
Before plugging the Display into the mains supply, connect the supplied IR receiver to the IR input on the
Display. Place the IR receiver in sight of your own remote control. Simply operate your remote control whilst
pointed at the IR receiver and it will relay the control signal to your Display.
In case your Display has touch screen feature and if the IR receiver is going to be placed on the Display it
shouldn’t be placed facing the inside of the screen, otherwise the signals of the touch screen and the remote
may interfere with each other. To improve the performance of your remote control place the IR receiver as
shown in the drawing below.
Front side of the Display
