VESTEL 55FA9000, Руководство по эксплуатации

Страница: 78 / 122

English - 76 -
Switching On/Off
To Switch the TV On
Connect the power cord to a power source
such as a wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode
either:
• Press the Standby button, Pro/-
or a numeric button on the remote control.
• Press the Standby button or Programme
+/- on the TV.
The TV will then switch on.
To Switch the TV Off
Press the Standby button on the remote
control or press the Standby button on the
TV, then the TV switches into standby mode.
To power down the TV completely, unplug
the power cord from the mains socket.
NOTE:
When the TV is switched into
standby mode, the standby LED can blink to
indicate that features such as Standby Search,
Over Air Download or Timer is active. The
LED can also blink when you switch on the
TV from standby mode.
First Time Installation
When turned on for the first time, the
language selection screen is displayed. Select
the desired language and press OK .
On the next screen, set your preferences
using the directional buttons.
NOTE : Depending on the Country selection you
may be asked to set and confirm a PIN at this
point. The selected PIN cannot be 0000. You
have to enter it if you are asked to enter a PIN
for any menu operation later.
About Selecting Broadcast Type
Digital Aerial:
If Digital Aerial broadcast
search option is turned on, the TV will search
for digital terrestrial broadcasts after other
initial settings are completed.
Digital Cable: If Digital Cable broadcast
search option is turned on, the TV will search
for digital cable broadcasts after other initial
settings are completed. According to your
other preferences a confirmation message
may be displayed before starting to search.
Select YES and press OK to proceed. To
cancel operation, select NO and press OK .
You can select Network or set values such as
Frequency , Network ID and Search Step .
When finished, press OK button.
NOTE : Searching duration will change depending
on the selected Search Step.
Satellite: If Satellite broadcast search
option is turned on, the TV will search for
digital satellite broadcasts after other initial
settings are completed. Before satellite search
is performed some settings should be made.
Digiturk Option
If desired, you can search and store Digiturk
channels. Before the satellite search starts, a
menu will be displayed where you can select
to install Digiturk channels. Set the Install
Type as Operator and than set the Satellite
Operator accordingly.
If you select Digiturk operator, next menu
item will be Select Satellite . Set the satellite
and press OK to proceed.
If you select Standard as Install Type and
press OK , Antenna Type menu will be
displayed first. You can select Antenna Type
as Direct , Single Satellite Cable or DiSEqC
switch by using “ ” or “ ” buttons.
• Direct: If you have a single receiver and a
direct satellite dish, select this antenna type.
Press OK to continue. Select an available
satellite on the next screen and press OK
to scan for services.