5
3
13
2
4 1 4
2
3
9
10
11
12
5
6
7
8
5
CONTROLS AND FUNCTIONS
TOP PANEL
i
PHONES JACK
Use this jack to connect the head phones. Head
phones from 8 ohm to 600 ohm can be used.
150 ohm is recommended.
o
MASTER LEVEL
Adjusts the signal level output from the LINE
OUT jack on the rear panel.
!0
MASTER BALANCE
Adjusts the signal balance of the left and right
side of the outputs from the LINE OUT jack on the
rear panel.
!1
MONITOR LEVEL
Adjusts the head phone output level.
!2
MONITOR SELECT FADER
When the monitor levels of PGM1 and PGM2
are properly set, PGM1 will be monitored in the
headphone with the fader set to the left side and
PGM2 will be monitored in the head phone with the
fader set to the rigth side. When the fader is set in
the center, both programs will be monitored in
the head phone.
!3
MIC LEVEL
Adjusts the input level from all microphone
inputs.
q
POWER LED
The LED is lit when power is on.
w
INPUT SELECT SWITCH
Used to select the input (LINE or PHONO ) to be
sent to each PGM channel.
e
TRIM CONTROL
Adjusts the input level of each channel.
r
ISOLATOR (HI,MID,LOW)
Cuts and boosts each frequency range. The
level is flat when this knob is set at 12 o'clock.
t
INPUT FADER
Used to adjust the input level of each program.
Usually set at the 7-8 position.
y
INPUT LEVEL METER
The LED level meters indicate the input signal
level of each PGM channel.
u
CROSS FADER
When the input level of PGM1 and PGM2 are
properly set, PGM1 will be heard with the cross
fader set to the left side. PGM2 will be heard
with the cross fader set to the right side. When the
cross fader is set in the center, both programs
will be heard. This is a detachable fader for the
ease of replacement with "CF-RUS" "CF-R" or
"CF-PCV" when it is worn out.
