Vesta DWV303DB, Руководство пользователя

Страница: 6 / 16

4
Outlet
Hose Hanger
Floor Standpipe Drain
Standpipe
Sink Drain W/ "Y" Branch Tailpiece
Sink
WATER DRAINAGE OPTIONS
3-Prong
Electrical
Installation Block
Drain
Connection
Supply
Connection
Trim Kit
BUILT-IN
(side view)
Dishwasher
Opening: Min. 23" Wide
Electrical
Water
Outlet
Water
Inlet
Min.
Deep
Water
Supply
CUTOUT FOR BUILT-IN
Opening: Min.
TRIM KIT DIMENSIONS
If you specifi ed a built-in installation, your dishwasher
came with the Built-In Hose Kit (Part# DWVBIHK) and
Built-In Trim Kit (Part# DWVTKBL).
Installation Location
- This dishwasher is approved for built-in installations.
- Air space requirements: Sides and Bottom=1/4” (.6
cm), Top=1” (2.5 cm), Rear=2” (5.08 cm)
- The water inlet hose from the machine terminates in
a 3/4” “female” connector. The water supply should
therefore terminate in a similar “male” connector and
should have a shutoff close by in the pipe.
- Make sure the HOT water supply faucet connection is
within easy reach of the machine. The fi ll-drain hose
assembly is 5 Feet (152.4 cm) long.
Water Drainage
- Standpipe Drain System: No point of the drain hose
must ever be placed higher than the top of the ma-
chine. If this should ever happen, the functioning of
the machine can be affected.
- Sink Drainpipe System: When routing the drain hose
through cabinets or walls, use a protective material
such as electrical or duct tape to cover sharp edges
that could damage the drain hose. Use a suitable
clamp to secure the drain hose to the “Y” branch
or disposer. With a sink drainpipe system, you may
connect directly:
1) To a disposer by following the
manufacturers attachment method. 2) directly to a “Y”
branch tailpiece (available at most hardware stores).
BUILT-IN INSTALLATION
INSTALLATION INSTRUCTIONS
Width: 25”
Width: 22-5/8”
Height:
20-1/2”
20-5/8”
18-1/8”
H
igh
Height:
17-1/4”