Vessel IPC40-E, Инструкция по эксплуатации

Страница: 18 / 36

18
„ Installation
Electrical power wiring
WARNING
Remember
Use IPC40-E only with 230V AC(50/60Hz). Use of other voltage may result in
fire and electric shock.
Remember
To prevent electrical shock accidents, be sure to unplug the power cord from
the outlet before performing any wiring.
Remember
To prevent electrical leaks, electrical shocks, and fire accidents, perform the
wiring work in accordance with electrical equipment technology standards and
in-house wiring provisions.
Check the specifications
Check to make sure the specifications of the supplied power makes the unit’s power specifications.
Wiring circuit breaker
Use a wiring circuit breaker to prevent overloading. It is also recommended that a ground-fault
interrupter be installed.
Extension cord
When an extension cord is used to supply power from a distant location, if the core wire of the
extension cord is narrow, it could cause a voltage drop and make it difficult for the unit to start and
prevent the capacity from being fully realized, so make sure the extension cord has sufficient
capacity to carry the electrical load. In addition, carrying a current that exceeds the allowable current
value could damage the cord’s insulation.
Power cord
The power cord comes with a plug, so plug it completely
into the oulet (230V AC).
Static eraser
The static eraser’s operation mode selector switch is set to automatic operation to link operation with
this unit.
Duct piping
Exhaust port
An exhaust port is provided on the rear of the dust collector.
The flange for connecting ducts with a 100 mm inside diameter is an option.
*Please be aware that connecting a duct will reduce the dust collecting capability.