Installation 3
VES, LLC
eView Installation Manual VF3510-00, Revision E01.06
10 of 16
This section provides instructions for connecting cables, mounting and testing the eView.
To complete the installation:
Install this product in accordance with NFPA 72, the National Electrical Code and all local codes.
Before You Begin
Before you begin the installation, take a few minutes to review the installation information, gather the required items,
and complete the tasks listed below to make the installation as quick and easy as possible.
Acquire the following items that are not included with the eView, but may be required for the installation:
Mounting
Determine the best location for the eView before mounting it. Surface mounting devices should be mounted on a dry,
flat surface. Position the device for mounting so that it is at eye height and level.
Secure the eView to a mounting location using four-screws that are 1/64” in diameter.
The eView should not be mounted in the proximity of heat sources or placed inside enclosures that do not have ade-
quate ventilation.
Cables should be connected using suitable cable connections. If additional cable entry points are required, all debris
caused by drilling of additional cable entries must be cleared before power is applied.
1
Notify the monitoring center and local security that the eLAN or Elite Panel will be temporarily out of service
when installing the eView.
2
Remove the eView from its packaging and check its contents.
3
Mount the eView and connect cabling for power and communication.
4
Applying power to the eView.
5
Configure the eView using eSP Discovery when networking eLAN Panels on the VESNet or configure the
eView using Loop Explorer when networking Elite Panels on the eNet.
Item
Quantity
Description
Communication Cabling
1
Specify required lengths of 14 through 24 AWG.
Power Cabling
1
Specify required lengths of 14 through 24 AWG.
Ground Strap
1
A ground strap is required for handling circuit boards.
The ground strap is not provided in the packaging of the eView.
Section 3
Installation
