Vertiv SmartRow DCR, Инструкция по установке и эксплуатации

Страница: 65 / 102

4. Reset the UPS that powers the SmartRow DCR control circuit and fire-suppression control
circuit.
a. If the SmartRow DCR is powered by a stand-alone Liebert UPS, refer to the corresponding
procedure in the manual for the UPS to start-up the UPS. If it will not restart, put the UPS
in bypass and restart the remaining equipment. For assistance putting a Liebert 3-phase
UPS in bypass and for service support, call 800-543-2378. For a Liebert single-phase UPS,
call 800-222-5877, option #1.
b. If the SmartRow DCR controls, and emergency fans are connected to rack-mounted
UPSs, you must manually restart the UPS(s). Refer to the corresponding procedure in the
manual for the UPS to start-up the UPS.
The Fire-suppression System is protected from commercial power failures by an integrated battery and
battery charger. In the event of a commercial power failure, the fire-suppression system continues to
operate in idle mode from this battery for up to 48 hours. Upon restoration of commercial power, the
battery charger automatically recharges the battery to float state.
7.3 Recovering from a Fire Suppression System Activation
In the event of a fire suppression system activation, contact your local fire-suppression representative for
proper guidance on bringing your system back on-line.
Vertiv | SmartRow DCR Installer/User Guide | 65