Vertiv NetSure SCC, Руководство пользователя

Страница: 21 / 36

Vertiv
| NetSure™ SCC Controller User Manual (UM1M520HNA) | Rev. H
21
WEB Interface Setup Procedures
Refer to the following procedures to set up the SCC Controller for Web Interface access.
Setting IP Communications Parameters
The controller can be factory configured with DHCP enabled or disabled. If DHCP is enabled, you will need to
get the IP address from the DHCP server which provided the IP address. If DHCP is disabled, then the
controller’s IP parameters (IP, subnet mask, and gateway addresses) must be set to match your company’s
network settings. The default settings for these parameters are shown below.
•
IP Address: 192.168.1.2
•
Subnet Mask Address: 255.255.255.0
•
Gateway Address: 192.168.1.1
The IP communications parameters are displayed and can be changed after a successful Web Interface login.
See “Logging into the Controller” on page23.
Connecting the Controller to your Local Area Network (LAN)
An Ethernet port is provided in the system. This port supports Dynamic Host Configuration Protocol (DHCP)
function. Connect the Local Area Network (LAN) to the Ethernet port. Refer to your system documentation for
location.
Connecting the Controller Directly to your Computer
An Ethernet port is provided in the system. This port supports Dynamic Host Configuration Protocol (DHCP)
function. Connect your computer to the Ethernet port after performing the following procedure. Refer to your
system documentation for location.
Use the following procedure to configure the computer connected directly to the controller.
Procedure
NOTE!
Windows 7 operating system is used in this procedure, other operating systems are similar.
1. Record your computer’s network settings by launching Control Panel in your computer. Navigate
through Network and Sharing Center
 Local Area Connection  Properties  Internet Protocol
Version 4 (TCP/IPV4)  Properties.
2. Record whether the "Obtain an IP address automatically" or "Use the following IP address" button is
selected. If "Use the following IP address" button is selected, also record the following:
IP Address:
Subnet Mask:
Default Gateway:
3. Record your controller’s network settings. These are either the default settings or settings a User
previously programmed into the controller. Default settings are listed on the Configuration Drawing (C-
drawing) furnished with your system. See also “Setting IP Communications Parameters” on page 21.
Record if DHCP is enabled or disabled. If DHCP is disabled, also record the following controller’s IP
parameters: