Vertiv Liebert NXL 500kVA, Руководство по установке

Страница: 32 / 76

Vertiv | Liebert
®
NXL
™
500-750kVA UPS Installation Manual | 26
3.2.2 Programmable Relay Board
The Programmable Relay Board (PRB) provides a means to trigger an external device when an
event occurs in the Liebert
®
NXL
™
. Each PRB has eight channels. Each channel has Form-C dry
contacts rated at 1A @ 30VDC or 125VAC @ 0.45A.
Any alarm/event can be programmed to any channel or channels. Up to four events can be
programmed to a relay. If multiple events are grouped to one relay, group the events logically to
simplify troubleshooting when an event is triggered. The same alarm/event can be programmed
to more than one channel. Up to two Programmable Relay Boards can be installed in the Liebert
®
NXL
™
for a total of 16 channels. Programming is performed through the HMI touchscreen display.
Figure 15 Control wiring, Programmable Relay Board
NOTE
Up to two PRB’s can be installed in the Liebert
®
NXL
™
.
Table 9 Programmable Relay Board pinout
Terminal
Block Channel Pin No. Common
Normally
Closed
Normally
Open
J71
CH1
A 1-3 1 2 3
B 4-6 4 5 6
CH2
A 7-9 7 8 9
B 10-12 10 11 12
CH3
A 13-15 13 14 15
J72
B 1-3 1 2 3
CH4
A 4-6 4 5 6
B 7-9 7 8 9
CH5
A 10-12 10 11 12
B 13-15 13 14 15
TB3
CH6
A 1-3 1 2 3
B 4-6 4 5 6
CH7
A 7-9 7 8 9
B 10-12 10 11 12
CH8
A 13-15 13 14 15
J74 B 1-3 1 2 3
Note: Pin 16 not used on J71, J72, and J73.
1 2 3 6 7 8 9 4 10 5 111213141516
1 2 3 6 7 8 9 4 10 5 11 12 13 14 15 16
1 2 3 6 7 8 9 4 10 5 11 12 13 14 15 16
1 2 3
J74
J71
J72
J73
1. Customer control wiring connection
points are terminals 1 through 15.
(Pin 16 not used on J71, J72, and
J73.)
2. Programmable Relay Board option
includes eight signal channels with
two Form-C dry contacts per
channel (see
Table 12 ).
3. All control wiring (by others) must
be run separate from power wiring.
Control wiring runs should not be
combined in the same conduit.
4. Contact ratings: 1A @ 30VDC or
125VAC @ 0.45A
5. Maximum cable length 500 ft.
(152m) with #16AWG and flexible
stranded cable.