Vertiv EDGE-1000IMT, Инструкция по установке и эксплуатации

Страница: 17 / 68

3.9 Network Communication Card Connection (Optional)
Advanced monitoring and simple control of the EDGE can be done with the use of a Vertiv Liebert
IntelliSlot Unity Communications card. Visit www.vertiv.com/intellislot for additional information.
To install the card:
1. Remove the two screws and protective cover on the rear-panel Network Communications Port.
2. Insert the card into the port and secure it with the screws. Refer to the documentation with the
card or at the link above for cable connection and operation.
3. Refer to the documentation with the card or at www.Vertiv.com for cable connection and
operation.
3.9.1 Connecting AC Input
Ensure that all the loads are first powered off. Connect to an input-power supply/wall outlet that is
properly protected by a circuit breaker in accordance with national and local electrical codes. The input
receptacle must be grounded. See Specifications, for input cord rating. Once the UPS is plugged into the
wall outlet, it begins charging the battery.
NOTE: While every precaution has been taken to ensure that the battery is in good condition, we
recommend allowing the UPS to be plugged into AC input and to charge the battery for at least 12
hours prior to providing full back-up time protection for any utility-power abnormality.
3 Installation
13
Liebert® EDGE Installer/User Guide