20
Installation, Operation & Service Manual
f. The cooling system is not
working properly.
f. Call for service.
Ice cubes are hollow
a. The icemaker thermostat is
defective.
b. The icemaker water pump is
defective.
a. Call for service.
b. Call for service.
Ice cubes are frozen
together in the ice bin
a. If ice cubes haven’t been used
for a long period of time, they
may freeze together.
b. Ice cubes are produced
continuously because the
feeler arm is blocked up
.
c. The freezer door is not closed
properly.
d. The icemaker is not working
properly.
e. The cooling system is not
working properly.
a. Pull out the ice bin and shake it or
remove the large clumps of ice cubes.
b. Clear ice cubes around the feeler arm.
c. Check for the door seal or door
opening.
d. Call for service.
e. Call for service.
Crushed ice is not
dispensed
a. There are not enough ice
cubes in the ice bin.
b. Ice cubes are frozen together
in the ice bin.
c. The freezer door is open.
d. The freezer door magnetic
switch is defective.
e. The auger motor is broken.
f. The flap motor is broken or has
wiring problems.
g. Control PCB is defective or
has wiring problems.
h. Display PCB is defective or
has wiring problems.
a. See
Icemaker is not producing ice
or
Icemaker is not producing enough
ice or ice cubes are small
.
b. Pull out the ice bin and shake it or
remove the large clumps of ice cubes.
c. Close it.
d. Replace it.
e. Call for service.
f. Call for service.
g. Call for service.
h. Call for service.
Cubed ice is not
dispensed
a. There are same problems as
crushed ice.
b. The solenoid is defective.
a. See
Crushed ice is not dispensed.
b. Call for service.
Hot water is not hot
a. The water heater stops
working automatically when
“Low” indicator appears.
b. The hot water function is
turned off.
c. The water heater is broken.
d. The thermostat is defective.
a. See
“Low” indicator appears
.
b. Turn the hot water function on.
c. Call for service.
d. Call for service.
Hot water is not hot
enough
a. The thermostat is defective.
a. Call for service.
Hot water heater
smells
“hot”
a. The hot water tank is dry
boiling.
a. Call for service.
Water dispensing is
not working
a. The water dispensing valve
stops working automatically
when “Low” indicator appears.
b. Air is trapped.
c. The dispensing valve water
tubes are broken.
d. The water dispensing valve is
defective.
e. Control PCB is defective or
has wiring problems.
a. See
“Low” indicator appears
.
b. Release cups of water from the water
release drain.
c. Call service.
d. Call service.
e. Call service.
f. Call for service.
