Vertex Standard VX-P820 Series, Руководство по эксплуатации

Страница: 13 / 40

11
VX-P820 S
erieS
O
Perating
M
anual
B
efore
y
ou
B
egin
Battery Pack Installation and Removal
r
To install the battery, hold the transceiver with
your left hand, so your palm is over the speaker
and your thumb is on the top of the belt clip.
Carefully mate the battery’s four insertion slots
with their corresponding alignment tabs on the
transceiver case, while tilting the Belt Clip out-
ward. Proper alignment occurs with the battery
pack offset about 1/2 inch (1.5 cm) from the top
edge of the battery compartment.
r
Guide the pack on to the tabs with a slight inward
pressure, then slide the battery pack upward, until
it locks in place with a “ Click ”.
Insert the Battery Pack
Tilt the Belt Clip
r
To remove the battery, turn the radio off and re-
move any protective cases. Slide the Battery Pack
Latch on the bottom of the radio toward the front
panel while sliding the battery down about 1/2
inch (1.5 cm). Then lift the battery out from the
radio while unfolding the Belt Clip.
Do not attempt to open any of the recharge-
able Lithium-Ion packs, as they could ex-
plode if accidentally short-circuited.
WARNING
The IS version of the VX-P820 is only intrin-
sically safe with the use of the FNB-V129LI-
IS-UNI Battery Pack. To acquire the IS ver-
sion of the VX-P820 , you much select the
Intrinsically Safe battery option at the time of
purchase. Replacement FNB-V129LIIS-UNI
battery may also be purchased however to be
considered IS the radio must have originally
been purchased with the IS battery option.
¦
Do not reverse-connect the battery terminals.
¦
Do not parallel-connect the battery terminals.
¦
Do not charge batteries in hazardous loca-
tions.
¦
To reduce the risk of explosion, recharge
the batteries outside of hazardous locations.