After creating CF1 and CF2 cards, follow the instructions below
*We recommend you save to the CF card, any personal settings you want to restore after the update. Please
see the DMU-2000 Data Management Operation Manual for the procedure to save your settings to a CF
card. Map and Time settings will be set to default.
*When you insert the CF card into the slot, please insure that the white side (ridge side) of the CF card
is up. If the CF card is inserted incorrectly, the DMU-2000
may be damaged.
1.
Turn off the DMU power switch on the rear panel and wait 1 minute.
2.
Connect a keyboard, if one is not already connected.
3.
Insert the system Compact Flash Card
CF1
(V0.xx-sys)
into the DMU card slot.
4.
Turn the DMU rear panel power switch on.
5.
When the question appears, “CF has system update file, Are you sure to update? (y/n)>”
Please answer
yes
(y + enter).
6.
Wait a minute for the system to check the current version. The program level will be shown on the
monitor display. Answer yes or no (y + enter, or n + enter) from the keyboard to each question of
the install sequence. If the present version and the new version listed on the screen are identical
numbers, you should answer
no
. (If you answer no, when the screen blanks, remove the
CF1
card,
or the system will repeat the sequence.) If the new version is higher, answer
yes
(y + enter).
7.
When programming is complete, the screen will be blank. Remove the
CF1
card and Turn the
rear panel DMU power switch off. Wait one minute.
Now you can insert CF2 (app) and Follow the same procedure instructions 1 thru 7:
8.
When programming is complete, remove the Compact flash card
CF2
(V0.xx-app). Turn the rear
panel DMU power switch off. Wait one minute.
9.
Turn on the FT-2000/D, FT-950 or FTdx5000 and the DMU-2000 rear and front power switches,
and confirm the DMU firmware is updated to V4.21 or V5.11 depending on the type of DMU-
2000 computer. Refer to the top of page 1 to check which version DMU software you have on
your unit.
10.
You will need to re-enter your map location, clock and other settings if necessary. The updating
process is now complete.
We hope this new software will increase your enjoyment of your DMU-2000. Thank you for choosing
Yaesu radios. If you have any problems or questions please contact Vertex Standard, Amateur Tech
Support.
Best regards,
Mikio Maruya, WA6F
Executive Vice President
Engineering & Customer Service
Vertex Standard USA, Inc.
Vertex Standard USA, Inc. | 10900 Walker St. | Cypress, CA 90630 | 714.827-7600 | FAX: 714.827-8100
www.vertexstandard.com
