Vertex™
Filter Sock Instruction Manual
©Vertex Aquaristik ™ 2018
P
ag
e
-
3
-
Important Points:
It is always best to vent the reactor for a few minutes to remove any remaining debris and/or
fine particles remaining in the media. To do so, simply remove the reactors exit line out of the
sump or aquarium and collect the effluent in a bucket or container. Once ensured that the
effluent is free of dust, fine particles or undesired coloration, place the exit line back in the
intended spot in the sump and/or aquarium.
Use only quality media. Vertex Aquaristik™ offers a ra
nge of media for most of your
applications.
Do not exceed the recommended amount of media for your systems net water volume. It is
recommended to start at a smaller dose and increase gradually to the desired amount over a
period of time. Rapid changes in water chemistry can negatively affect your systems
inhabitants.
Always follow manufacturer guidelines for required amount of media or additives. Vertex
Aquaristik™ cannot be held accountable for any damages excess flow through the reactor,
excess use of media and/or additives dosed can cause. If you are unsure of the proper amount
of flow and/or media required, contact the manufacturer directly.
Any media will be exhausted in time and needs to be exchanged or replenished. For proper
media renewal regimens, please consult with the media manufacturer.
Maintenance:
After extended operation time or when deemed necessary, lubrication can be applied on the O-rings.
Only use food grade silicone grease. The unit can be fully disassembled for cleaning and/or
maintenance. Refer to the assembly instruction of this guide before putting the unit back in operation.
A-
Turn the pump off and disconnect form power. Do not attempt to service or perform
maintenance on the unit when connected to power.
B-
Close the onboard valve.
C-
IN external applications, it is best to secure the reactor in a container to avoid any spillage
disconnection of the hoses and/or plumbing can cause.
D-
Open the unions and remove the reactor.
E-
Gently turn the lid in a counter clockwise motion to open. Refrain from applying force to the
connections.
F-
Loosen the Titanium Screw onboard the top perforated plate.
G-
Remove the media.
H-
To bring the reactor back online, simply refer to the assembly part of this guide.
I-
Tighten lid and make sure all the connections and unions are properly assembled and seated.
J-
Turn the unit back on and ensure proper flow for the amount of media being utilized.
