![VersaLogic Iguana VL-EPIC-25 Скачать руководство пользователя страница 36](http://html.mh-extra.com/html/versalogic/iguana-vl-epic-25/iguana-vl-epic-25_reference-manual_1006776036.webp)
Interfaces and Connectors
VL-EPIC-25 Reference Manual
30
S
TATUS
LED
Connector J28 provides an additional on-board Ethernet status LED interface. The +3.3V power
supplied to this connector is protected by a 1 Amp fuse.
Table 7: Ethernet Status LED Pinout
J28
Pin
Signal
Name
Function
On-Board LED
Equivalent
1
+3.3V
Protected Power Supply
—
2
YEL1
Yellow LED - Ethernet 0
D7
– Yellow
3
ORN1
Orange LED - Ethernet 0
D8
– Yellow
4
GRN1
Green LED - Ethernet 0
D8
– Green
5
+3.3V
Protected Power Supply
D9
– Yellow
6
YEL2
Yellow LED - Ethernet 1
D10
– Yellow
7
ORN2
Orange LED - Ethernet 1
D10
– Green
8
GRN2
Green LED - Ethernet 1
—
9
GND
Ground
—
10
W_DISABLE#
PCIe Mini Card Disable*
—
* This pin can be connected to the Disable signal on the PCIe Mini Card
(pin 20) on custom models.
SATA Interface
The Iguana provides two serial ATA (SATA) ports, which communicate at a rate of up to 3.0
GB/s (SATA 2). The SATA connectors at locations J11 and J12 are standard 7-pin straight
SATA connectors with friction latching. Power to SATA drives is supplied by the ATX power
supply. Note that the standard SATA drive power connector is different than the common 4-pin
Molex connector used on IDE drives. Most current ATX power supplies provide SATA
connectors, and many SATA drives provide both types of power connectors. If the power supply
you are using does not provide SATA connectors, adapters are available.
Table 8: SATA Port Pinout
J11 or
J12 Pin
Signal Name
Function
1
GND
Ground
2
TX+
Tr
3
TX-
Transmit -
4
GND
Ground
5
RX-
Receive -
6
RX+
R
7
GND
Ground
The blue LED at location D11 (upper right corner of the board as shown in Figure 7) lights with
disk activity on the SATA ports.