Versalift VST-39-TN, Руководство оператора

Страница: 52 / 55

6-2 39020-02 08/16 VERSALIFT VST-39/43/50/55-TN
DAIL
Y
VISUAL
INSPECTION
EXTENSION SYSTEM - While operating the unit from
the lower controls, observe the extension system
during operation. First, raise the outer/inner boom
assembly to a maximum upright position, and then
fully extend the inner boom. Next, lower the outer/
inner boom assembly to a position slightly below
horizontal, and then retract the inner boom. Extension
and retraction of the inner boom should be smooth.
Also, listen for any abnormal noises while extending
and retracting, which could indicate a potential
problem and warrant further inspection of the
extension system.
LEVELING SYSTEM - Inspect the master cylinder,
slave cylinder, hoses, and fittings for damage, wear,
or foreign objects which may prevent proper
operation. Refer to Parts & Assemblies in the Service
and Installation Manual for these components. Also
inspect the protective fiberglass covers, on each side
of the slave cylinder, for cracks or damage. If these
conditions exist they must be repaired by qualified
personnel before operation.
DECALS - Identification, operational, and instructional
decals are installed at numerous locations on the
Versalift . These decals must be replaced if they
become lost, damaged, or illegible. Refer to the
“Decal Placement” illustration in this section.
ROPE - Make a thorough check of the winch rope for
abrasive wear, pulled strands, cuts, and other
defects. The rope should be clean and dry. The rope
coils should spool evenly on the winch reel. Do not
use a rope that has been subjected to shock loads.
Replace the winch rope at the first sign of damage or
deterioration. Use only non-conductive rope of the
size and type specified.
WINCH - Verify that the rope coils are spooling
evenly. Check for hydraulic leaks as well as leaks
from the winch drive gearbox.
SLOPE INDICATORS - The indicators are installed
at several locations on the Versalift chassis. Check
that indicators are in place and not damaged. Refer
to slope indicator installation in the Service Manual.
SAFETY DEVICES – Check visual and audible safety
devices for proper operation.
COVERS – Inspect all covers to make sure they are
in place, secure and in good condition.