NOTE:
IT IS IMPORTANT TO TIGHTEN THE FOOT
PEDALS SECURELY INTO POSITION.
INJURY MAY RESULT AND DAMAGE TO
THE MACHINE MAY OCCUR IF THEY ARE
NOT PROPERLY FASTENED.
Bolt foot pedals on machine, with " L" pointing
up, using two 3/8" x 1
1/4"
long hex head bolts.
Tighten the 5/8” x 4
1/4”
long bolts securely
using the two crescent wrenches.The hand
rails are now securely attached to each of the
machine posts and the machine base plate.
Using two people lift VersaClimber to upright
position.
With one person standing on the base plate,
support mainframe the other person places
the previously assembled support brace into
position as shown above.
Next, attach the brace at the upper joint first
using the 2
1/4”
bolt, (2) washers and self-
locking nut.
Attach the bottom joint of the support brace
using the self locking nut.
Raise or lower the brace in the slot until the
machine is stable “front to back”, flush on the
ground. Then fully tighten both nuts.
Tighten floor tie. Tighten locknut at bottom
of angle brace.
The machine is now free to stand on its own.
Page 28
