Verona VEFSGE 304 SC, Руководство по установке

Страница: 21 / 24

21
3
3-Wire Conduit Installation
(See Figure 3.5)
1. Remove the Terminal Block Access Plate on the back of the
range by unscrewing the 4 fixing
Screws
(Figure 3.4).
2. Check the correct positioning of the Conduit Bracket as per
figure 3.5.
3. Feed 1/2” (1.3 cm) trade size Conduit through the hole in the
Conduit Bracket and secure to the Conduit Bracket with a
Conduit Clamp .
4. Plug the terminal holes of conductors.
The Neutral or Ground Wire must be connected to the neutral
terminal located in the center of Terminal Block .
The Power Wires must be connected to the outside terminals.
5. Plug washers and tighten nuts securely.
Do not remove
Ground strap
.
6. Reassemble the Terminal Block Access Plate on the back of
the range by screwing the 4 fixing Screws (Figure 3.4).
4-Wire Conduit Installation
(See Figure 3.6)
1. Remove the Terminal Block Access Plate on the back of the
range by unscrewing the 4 fixing Screws (Figure 3.4).
2. Check the correct positioning of the Conduit Bracket as per
figure 3.6.
3. Feed 1/2” (1.3 cm) trade size Conduit through the hole in the
Conduit Bracket and secure to the Conduit Bracket with a
Conduit Clamp .
4. Remove the 3 wire terminal nuts and washers from the Termi-
nal Block .
5. Remove the Ground Strap from the frame of range and termi-
nal by removing its screw and cutting it as shown in Figure 3.6.
6. Plug the terminal holes of conductors.
The
Neutral Wire
must be connected to the neutral terminal
located in the center of Terminal Block ; the Power Wires must
be connected to the outside terminals; the Ground Wire must
be attached to the frame of range by using the (Ground) identi-
fied Grounding Screw .
7. Plug washers and tighten nuts securely.
8. Reassemble the
Terminal Block Access Plate on the back of
the range by screwing the 4 fixing Screws (Figure 3.4).
Terminal Block
Ground strap
Neutral Wire
Power Wires
Conduit
Conduit Clamp
B
Power Cord
Bracket
A
: D=1” 9/64 (29 mm)
B
: D=7/8” (22.5 mm)
A
Terminal Block
Cut Ground Strap
Neutral Wire
Power Wires
Conduit
Conduit Clamp
Grounding Wire
Grounding
Screw
B
Power Cord
Bracket
A : D=1” 9/64 (29 mm)
B
: D=7/8” (22.5 mm)
A
Terminal Block
Access Plate
Screws
Screws
Fig. 3.4
Fig. 3.5
Fig. 3.6