Verona VEFSGE 304 SC, Руководство по установке

Страница: 20 / 24

20
3
3-Wire Power Cord Installation
(See Figure 3.2)
1. Remove the Terminal Block Access Plate on the back of the
range by unscrewing the 4 fixing
Screws
(Figure 3.1).
2. Check the correct positioning of the Power Cord Bracket as
per figure 3.2.
3. Assemble the strain relief in the hole on Power Cord Bracket .
4. Insert the Power Cord through the strain relief and tighten.
5. Remove the 3 wire terminal nuts and washers from the Termi-
nal Block .
6. Plug the terminal holes of Power Cord .
The Neutral or Ground Wire of the Power Cord must be con-
nected to the neutral terminal located in the center of Terminal
Block .
The Power Wires must be connected to the outside terminals.
7. Plug washers and tighten nuts securely.
Do not remove Ground strap .
8. Reassemble the Terminal Block Access Plate on the back of
the range by screwing the 4 fixing
Screws
(Figure 3.1).
4-Wire Power Cord Installation
(See Figure 3.3)
1. Remove the Terminal Block Access Plate on the back of the
range by unscrewing the 4 fixing Screws (Figure 3.1).
2. Check the correct positioning of the Power Cord Bracket as
per figure 3.3.
3. Assemble the strain relief in the hole on Power Cord Bracket .
4. Insert the Power Cord through the strain relief and tighten.
5. Remove the 3 wire terminal nuts and washers from the Termi-
nal Block .
6. Remove the Ground Strap from the frame of range and termi-
nal by removing its screw and cutting it as shown in Figure 3.3.
7. Plug the terminal holes of Power Cord .
The Neutral Wire of the Power Cord must be connected to the
neutral terminal located in the center of
Terminal Block
; the
Power Wires must be connected to the outside terminals; the
Ground Wire must be attached to the frame of range by using
the (Ground) identified Grounding Screw .
8. Plug washers and tighten nuts securely.
9. Reassemble the
Terminal Block Access Plate on the back of
the range by screwing the 4 fixing Screws (Figure 3.1).
Terminal Block
Ground strap
Neutral Wire
Power Wires Power Cord
Power Cord
Bracket
A : D=1” 9/64 (29 mm)
B : D=7/8” (22.5 mm)
A
B
Terminal Block
Cut Ground Strap
Power Cord
Bracket
Neutral Wire
Power Wires
Grounding Wire
Grounding
Screw
A
: D=1” 9/64 (29 mm)
B
: D=7/8” (22.5 mm)
Power Cord
A
B
Terminal Block
Access Plate
Screws
Screws
Fig. 3.1
Fig. 3.2
Fig. 3.3