Betriebsanleitung BARISSIMA, V 1.00, 02.2015, Deutsch
Seite 33
6
Troubles, Messages and Notes
6.1
Troubleshooting
If the milk foamer is turned on but you cannot get any products, check the following
points:
•
Check if a warning or error message is shown on the display
•
Check if the milk container is filled.
•
Check if the outlet head is properly connected.
•
Check if the filter membrane is dirty
•
If you still have not found a solution for the problem, contact your service partner for
assistance.
6.2
System Messages
6.2.1
General
System messages appear on the display.
They inform about the current state of the milk foamer.
Read the messages and perform the necessary steps.
6.2.2
Milk level too low (only with milk cooler with sensor)
Milk empty in the reservoir.
-
Fill the container with pre-cooled milk. See Chapter 4 "Operation".
6.2.3
Outlet head removed
Outlet head is removed or not inserted correctly.
-
Insert the outlet head.
6.2.4
Cleaning process not finished
Cleaning was started and not finished (refill fresh water).
-
Restart the cleaning program.
6.3
Error Messages
6.3.1
Boiler Temperature to high
Heating sensor defective or the cable is broken.
-
Call a service technician.
Important!
The integrated component-tested safety devices prevent unwanted pressure and
temperature increase in the hot water boiler. If the safety valve opens, the machine must
be switched off immediately at the main switch and the main shutoff valve to the drinking
water supply must be closed. If there are troubles, switch off the machine and call an
authorized service technician. Do not turn the machine on until the error is fixed.