Page 77 of 18
Port
Port Configurations is for configuring Serial parameters.
delimiters are received the data will not be transmitted successfully.
Port Alias : Remarks for the port.
Baud rate : From 110bps to 460.8kbps
Parity : No, Even, Odd, Mark, Space
Data Bits : 5, 6, 7, 8
Stop Bits: 1, 2 (1.5)
Flow Control : None, XON/XOFF,
RTS/CTS, DTR/DSR
Interface : RS232
Performance : “Throughput” : guarantees
highest transmission speed or “Latency” :
guarantees shortest response time.
Delimiter Settings
For advanced data packing options, you
can specify delimiters for Serial to
Ethernet and / or Ethernet to Serial
communications.
You can define 4 delimiters (00~FF,
HEX) for each way and until the
“Flush Ethernet to Serial Data Buffer After” is time for which data will be stored before getting transmitted
between Ethernet and Serial.
“Force TX interval time” is for specifying the timeout when no data has been transmitted and the timeout is
reached or TX buffer is full (4K Bytes), the queued data will be sent. If you want to disable and the parameter is
setting “0”. (factory default)
Service Mode : UDP Mode
When device is configured as TCP Server, it gives the connected serial device a unique IP : Port address on a
TCP/IP network that it can be accessed by other host on the network. Device as TCP Server waits passively to
be contacted by the host computer, allowing the host computer to establish a connection and get data from the
serial device.
