14
50004428
VM508 / VM658 Assembly
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or
moving the grill is recommended.
Step 18: Install the LP Cylinder
(LP Models ONLY)
Parts Required:
(1) LP Gas Cylinder (not included)
Figures 18 & 19
NOTE:
Check your User’s Manual for the cylinder filling requirements, how to attach the regulator and how
to test for leaks before you try lighting the grill.
CAUTION:
Make sure the hose is not touching any hot or sharp surfaces.
Place the LP Cylinder into the hole in the bottom panel. Next secure it from moving by lifting the cylinder
retainer wire and latching the bent edge over the lip of the cylinder. The final step is to connect the regula-
tor to the cylinder.
CAUTION:
Do not turn on/ignite the grill until after performing a leak check at all gas connection points and
fittings. With the main LP cylinder valve OPEN, and ALL CONTROL KNOBS FULLY OFF, use a spray solu-
tion of 50% liquid soap and 50% water onto all gas connection points and fittings. The formation of bubbles
indicates an air leak that must be repaired and verified with this leak test before the grill is ignited.
NOTE:
Ensure all plastic coatings have been removed from all stainless steel parts before using the grill.
����
������������
����
B119
Figure 18
����
��������������
����
B120
Figure 19
Step 19: Install Natural Gas Supply Line
(Natural Gas (NG) Models ONLY)
Figure 20
Run natural gas supply lne through bushing pro-
vided in back panel of grill.
����
����������������
�����
Figure 20
B240
