16
20304685
VC41LDVI/VC41CDVI Gas Fireplace Insert
INSTALLATION
INTAKe/exhAuST MANIFOLD ReMOVAL
AND VeNT INSTALLATION
The intake/exhaust manifold is shipped attached to insert.
It may be removed to allow tight installation.
1. Unfasten the two (2) machine screws on the face of the
unit and release the plate assembly by sliding the plate
back.
2. Attach the exhaust and the intake flex pipes to the collar
on the plates with a hose clamp (not provided) or other
approved methods (check local codes).
The unit is shipped from the factory without a baffle
installed. On the natural gas units, the baffle should be
sufficient for venting up to 20 feet (6 m) off the top of the
unit. An extra baffle plate is shipped with the unit for instal-
lations of 20 feet and above.
Remove four (4) screws holding baffle plate. Add extra
baffle pate and reinstall screws. Align slots in baffle plates
so the slots are closed. Retighten screws.
NOTe:
For propane (LP) units the baffle assembly is com-
pletely removed for venting under 20 ft. (6 m). For venting
20 ft. and above, the baffle assembly is to be used with
only one (1) baffle plate installed.
Figure 17
FP1961
baffle adjustment
9/08
Loosen Four (4) Screws to Adjust
Bottom View
Closed Position
Bottom View
Open Position
FP1961
Figure 17 -
Baffle Assembly and Adjustment
3. Slide plate assembly back in place under locating
tabs.
4. While sliding unit in place, if necessary the glass latch/
shutoff tool can be used to help place the plate assem-
bly. Using the small end of the tool, insert it in the square
notch in top front of firebox. Hook the plate assembly
with tool and pull forward into place while sliding firebox
to the rear.
Figure 16
5. Reinstall and tighten machine screws.
FP2977
latch tool plate assy
Plate
Assembly
Latch Tool
FP2977
Figure 16
FP2979
intake exhaust
Figure 15
Machine
Screws
Intake Collar
Exhaust/Intake
Slide Plate
Assembly
FP2979
Exhaust Collar
NOT
e
Failure to install the baffle assembly on
natural gas units may result in smaller than
normal flame appearance.
