Vermont Castings SDDVTBDSB, Инструкция по установке и эксплуатации

Страница: 25 / 64

25
3-90-20306760 Vermont Castings • Stardance SDDVTSB Installation Manual_R10 • 04/18
3. Install the left log by mating the hole on the bottom of the
log with the pin in the ember bed. (Figure 44) Position
the log over air hole in ember bed.
4. Install the right log by mating the notch on the bottom of
the log with the raised notch on the ember bed. (Figure
44) Position the log over air hole in ember bed.
5. Install top log by mating hole on bottom of log with
locating pin on top right side of rear log. (Figure 45)
Position log so it is angled down toward the area where
the front two logs meet.
Install Log Set
Before beginning log installation, remove stove front and
glass frame. Refer to Figures 41 and 43.
Before installation, inspect ember bed burner for damage.
Do not use ember bed if damaged or cracked. Small, shallow
surface cracks are acceptable.
1. Remove the logs from their packaging and inspect each
piece for damage. DO NOT INSTALL DAMAGED LOGS.
2. Install the rear log by mating the notch on the bottom of
the log with the raised notch on the back left side of the
ember bed. (Figure 44) Ensure the cutout in the right
side of the log is sitting around the pilot assembly and
pilot is not obstructed. (Figure 45)
Figure 44 - Rear Log
LG497
SDDVT ember bed
6/07
Raised Notch
Pin
Pilot Assembly
Raised
Notch
Figure 47 - Completed Installation
LG495
SDDVT logs complete
6/07
Rear Log
Top Log
Left Log
Right Log
Ember Bed
Figure 46 - Front Logs
LG494
left/right logs
6/07
Right Log
Left Log
Figure 45 - Ribs for Logs
Lg493
Rear log
6/07
Rear Log
Pilot
Assembly
DANGER
HOT GLASS WILL
CAUSE BURNS .
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
causer des brûlures.
Laissez refroidir le panneau
vitr é avant d’y toucher.
Ne laisser jamais les enfants
toucher le panneau vitr é .
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and shall be installed.
Une barrière visant à réduire le risque de brûlure
par le hublot chaude est fournie avec cet
appareil et doit être installé.
DANGER