Vermont Castings SA18SHKRN, Инструкция по установке и эксплуатации

Страница: 11 / 20

11 3311857
The pilot will resist lighting on new installa-
tions due to air in the gas supply line. It may
take several minutes to bleed air completely
out of the gas plumbing system through the
pilot line.
This appliance has a pilot which is lit by a spark
ignition device (piezo). If the piezo fails, then light
the pilot using matches following the Match Light-
ing instructions below.
1. STOP! Read the safety information above.
2. Push in gas control knob slightly and turn clock-
wise to “OFF”.
3. NOTE: Knob cannot be turned from “PILOT”
to “OFF” unless knob is pushed in slightly.
Do not force.
4. Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP! Follow the safety
information above. If you don’t smell gas, go on
to the next step.
5. Turn the control knob counterclockwise to
“PILOT” and push in. Continue to hold the con-
trol knob in and push the piezo igniter button in
until the pilot lights.
6. Continue to hold the control knob in for about
one (1) minute after the pilot is lit. Release the
knob and it will pop back up. Pilot should re-
main lit. If it goes out, repeat steps 3 and 4.
7. If the knob does not pop out when released,
stop and call your service technician or gas
supplier. If the pilot will not stay lit after several
tries, turn the gas control knob to “OFF’ and call
your service technician or gas supplier.
8. Turn gas control knob counterclockwise
to “ON”. CAUTION: Be sure ON/OFF/RS switch
is in the off (middle) position. Also, the GWSK
should be in the “OFF” position and/or the
remote should be in the “OFF” position before
turning the control knob “ON”. If pilot goes out,
repeat steps 4 and 5.
9. Turn ON/OFF/RS switch to “ON” or remote po-
sition. Turn remote switch to “ON”.
10. Flame is adjustable by rotating the “HI/LO”
knob.
Lighting the Pilot
Before operating, smell all around the appliance area for gas odor. Be sure to smell near the floor because
some gases (propane) are heavier than air and will “pool” on the floor.
Use only your hand to push or turn the gas control dial.
NEVER USE TOOLS. If the knob will not push in
or turn by hand, don’t try to repair it, call a qualified technician. Force or attempted repair may result in a
fire or explosion.
What To Do If You Smell Gas
•
Do not try to light any appliance
•
Do not touch any electrical switch, do not use any phone in your build-
ing
•
Immediately call your gas supplier from a neighbor’s phone. Follow the
gas supplier’s instructions
•
If you cannot reach your gas supplier, call the fire department
For Your Safety Read Before Lighting
WARNING: If you do not follow these directions exactly, a fire or explosion may result
causing property damage, personal injury, or loss of life.