3
Oxford Direct Vent / Natural Vent Gas Heater
30005123
General Information
The Oxford Direct Vent/Natural Vent Room Heater, Model
No. OXDV30NV, is a vented gas appliance listed to the ANSI
standard Z21.88-2009 and CSA-2.33-2009 for Vented Room
Heaters, and CSA 2.17-M91, Gas-Fired Appliances For Use
at High Altitudes.
The installation of the Oxford Direct Vent/Natural Vent Room
Heater must conform with local codes, or in the absence of lo-
cal codes, with National Fuel Gas Code, ANSI Z223.1/NFPA
54 — latest edition and CSA B-149.1 Installation Code. (EX-
CEPTION: Do not derate this appliance for altitude. Maintain
the manifold pressure at 3.5” w.c. for Natural Gas and 10.0”
w.c. for LP gas at maximum input.)
This appliance is only for use with the type of gas indicated
on the rating plate. This appliance is not convertible for use
with other gases unless a certified kit is used.
Installation and replacement of gas piping, gas utiliza-
tion equipment or accessories, and repair and servic-
ing of equipment shall be performed only by a qualified
agency, preferably NFI or WETT (canada) certified. The
term “qualified agency” means any individual, firm, cor-
poration, or company that either in person or through a
representative is engaged in and is responsible for (a)
installation or replacement of gas piping, or (b), the con-
nection, installation, repair, or servicing of equipment,
who is experienced in such work, familiar with all pre-
cautions required, and has complied with all the require-
ments of the authority having jurisdiction.
The Oxford Direct Vent/Natural Vent Room Heater should
be inspected before use and at least annually by a quali-
fied service agency. It is imperative that control compart-
ments, burners, and circulating air passageways of the
appliance be kept clean.
The Oxford Direct Vent/Natural Vent Room Heater and its
individual shut-off valve must be disconnected from the gas
supply piping during any pressure testing of that system at
test pressures in excess of 1/2 psig (3.5 kPa).
The Oxford Direct Vent/Natural Vent Room Heater must be
isolated from the gas supply piping system by closing its in-
dividual manual shutoff valve during any pressure testing of
the gas supply piping system at test pressures equal to or
less than 1/2 psig.
‘Direct Vent’ describes a sealed combustion system in which
incoming outside air for combustion and outgoing exhaust en-
ter and exit through two separate concentric passages within
the same sealed vent system. The system does not use room
air to support combustion. The Direct Vent system permits
the gas appliance to be vented directly to the outside atmo-
sphere through the side of the house or vertically through the
roof. Conventional venting systems (Natural Vent) take air
from the room for combustion and vent the exhaust vertically
through the roof to the atmosphere.
This appliance is approved for bedroom installations in the
U.S. and Canada.
This appliance may be installed in an aftermarket* manufac-
tured (mobile) home, where not prohibited by state or local
codes.
WARNING: Operation of this heater when not connected
to a properly installed and maintained venting system
can result in carbon monoxide (cO) poisoning and pos-
sible death.
The Oxford Direct Vent/Natural Vent Room Heater, when in-
stalled, must be electrically grounded in accordance with lo-
cal codes or, in the absence of local codes, with the National
Electrical Code ANSI/NFPA 70, (latest edition), or of the cur-
rent Canadian Electrical Code C22.1.
Due to high temperatures this appliance should be locat-
ed out of traffic and away from furniture and draperies.
WARNING: This appliance is hot while in operation.
Keep children, clothing, and furniture away. contact may
cause burns or ignition of combustible materials.
children and adults should be alerted to the hazards
of high surface temperatures and should stay away to
avoid burns or clothing ignition. Young children should
be carefully supervised when they are in the same room
as the appliance.
clothing or other flammable materials should not be
placed on or near the appliance.
Any safety screen, glass or guard removed for servicing
an appliance must be replaced prior to operating the ap-
pliance.
The appliance area must be kept clear and free from com-
bustible materials, gasoline, and other flammable vapors
and liquids.
The flow of combustion and ventilation air must not be
obstructed. The installation must include adequate ac-
cessibility and clearance for servicing and proper opera-
tion.
WARNING: Do not operate the Room Heater with the
glass panel removed, cracked or broken. Replacement
of the panel should be done by a licensed or qualified
service person.
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the con-
trol system and any gas control which has been under
water.
Do not burn wood, trash or any other material for which
this appliance was not designed. This appliance is de-
signed to burn either natural gas or propane only.
This gas appliance must not be connected to a chimney
flue serving a separate solid-fuel burning appliance.
cAUTION: Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper and
dangerous operation.
Verify proper operation after servicing.
proposition 65 Warning:
Fuels used in gas, woodburning or
oil fired appliances, and the products of combustion of such
fuels, contain chemicals known to the State of California to
cause cancer, birth defects and other reproductive harm.
California Health & Safety Code Sec. 25249.6
* Aftermarket:
Completion of sale, nor for purpose of resale, from the
manufacturer.
