13.
Install the new refractory package. Replace the catalyst. Install the access panel.
14.
Re-install the upper fireback assembly. If held in place with gasket, ensure it is in good condition before re-
installing. If held by cement, clean the grooves in the rear of the stove and the rear of the upper fireback before
re-cementing. Fasten it in place with two 1/4"-20 x 1-1/ 2" hex bolts and washers.
15.
Attach the handle and its 'faucet' to the damper handle rod with the Allen bolt, and test the damper for smooth
action.
16.
Re-install the left and right wear plates, each with their two bolts.
17.
Re-install the lower fireback, and secure it with two wedges. Gently tap with a rubber mallet to make sure the
top of the fireback seats tightly to the bottom of the upper fireback. If not, clean the groove it sits in again
and/or loosen the two bolts that hold the upper fireback in place and re-install the lower fireback. Tighten the
upper fireback outer bolts when finished.
18.
Replace the throat hood and re-install the andirons.
19.
To reinstall the probe, pilot (with your hand) a small hole into the combustion package through the hole in the
back of the stove with a bit of smaller diameter than the probe. Replace the assembly by inserting it into the
hole, hooking it onto the linkage and screwing it back onto the firebox.
