D100
2014-07
Page 16
3.3 Adjusting the seat height
The Vermeiren D100 is adjustable in 3 seat heights by changing the wheels position. At each
height there is a different setting of the front and rear wheels.
L
WARNING:
The top hole of the axle plate is not intended for mounting the rear
axle - This hole is for mounting the drum brake.
Seat height
Rear wheel
Front wheel
470 mm
Hole 1 and Hole 2
Hole A
500 mm
(Standard)
Hole 2 and Hole 3
Hole B
530 mm
Hole 3 and Hole 4
Hole C
Table 2: Seat heights
Change the seat height according the following steps:
1.
Remove the rear wheels (see § 2.13).
2.
Remove the screw from the plate.
3.
Assemble the plate in the right hole of the side
frame, see Table 2.
4.
Check if the axle bushings are fastened well.
5.
Remove the screw from the front fork and
wheels.
6.
Place it according table 2.
7.
Install the front wheels and tighten it. Check if it
turn smoothly, but there is no space for motion.
8.
Mount the rear wheels.
9.
If installed properly the fork of the front wheels
and the ground must be perpendicular. Check
this.
10.
Adjust the brakes according § 3.4.
Содержание D100
Страница 138: ... Notes ...
Страница 139: ......