Vermeiren Ceres SE, Инструкция по эксплуатации

Страница: 15 / 24

Ceres SE
2021-08
Using your scooter
13
EN
NL
3.7 Charging the batteries
Risk of injuries and damage due to fire

Only use the battery charger delivered with the scooter. The use of any other charger may be
dangerous (fire hazard).

The battery charger is only intended to charge the batteries delivered with the scooter, not to
charge any other batteries.

Do not adapt any of the delivered parts, like cables, plugs or battery charger. Never open or
change the battery or the connection points.

Protect the battery and battery charger against flames, high and low temperatures (see chapter
6), moisture, sunshine, severe shocks (for example dropping). Do NOT use the battery if this
has been the case.

Charge the battery with the battery charger, indoors, in a well-ventilated area, out of children's
reach.

First read the user instruction of the applied battery charger before charging the scooter’s
battery. For more information, contact your specialist dealer or consult our website
http://www.vermeiren.com/
Risk of damage

Battery self-discharge and the quiescent current of the connected users will drain the battery
charge slowly. The battery may be irreversibly damaged if the battery is fully discharged.
Therefore, make sure that the battery is charged on time:
o
With intensive use (long distances, daily use): Immediately recharge after use.
o
With average use (short distances, daily or a few times a week): Charge when battery
indicator shows 50% discharge.
o
With little use or storage: Charge once a week.

Read the storage and maintenance instructions in chapter 4 and technical
details in chapter 6.

Only disconnect the battery charger when the battery is fully charged, see
the following symbols on the charger.

Do not charge batteries below 0°C. Move the battery to a warmer place
and start charging.

Keep the connection point for the battery charger free of dust and other contamination.

In case of any problems whereby the battery cannot be charged according to following
instructions, please contact your specialist dealer.

For instructions on how to change the batteries, see the installation manual.

It is recommended to unplug the battery charger from the mains when not in use. This is
to prevent unnecessary energy consumption.
The light emitting diode (LEDs) in the steering unit indicates the remaining capacity of your
batteries. If the battery charger is turned on and no LED's are lit, check the fuse. If the red LED
does not illuminate, the charger is defective.Consult your specialist dealer.
1. Switch the scooter OFF and remove the key.
2. FIRST connect the battery charger to a 230V AC power socket.
3. If applicable, open the cover of the charging point on the scooter.
4. Connect the charger.
5. Refer to the battery-charger manual for the explication of the indicators on the charger.
6. When the battery is fully loaded, disconnect the scooter from the charger.
7. Switch the scooter ON and check if all lights of the battery status indicator are ON.
8. Remove the charger from the socket, let it cool down and store it in a dry location.
WARNING
CAUTION