Vermeiren Carpo 4 deluxe, Инструкция по эксплуатации

Страница: 28 / 40

Carpo 4 Deluxe
2012-04
Page 26
4.4 Inspection
In principle we recommend one inspection every year, and a minimum of one before usage is
resumed. All of the following checks must be performed and documented by authorized persons:
•
Visually check the frame parts for plastic deformation, cracks and impaired functioning. (basic
frame, seat frame, back frame, side parts, motor suspensions)
•
Visually check all plastic parts for cracks and brittle spots
•
Visually check all housings for damage, screws must be securely fixed, seals and gaskets
should not exhibit visible damage.
•
Check the solidity and seating of all screws.
•
Visually check for damage to the paintwork (danger of corrosion)
•
Check the operation of the wheels (free running, level rolling, axle play, tyres, profile, condition
of the rims, air pressure in the case of air tyres, floating axles, etc.)
•
Verify the amount of grease on the metal joints of movable parts (do not use WD40 lubricating
agents)
•
Check the functioning of the armrests (locking, load, deformation, wear caused by loads).
•
Check the operation of other detachable parts (example: personal safety belt, seat, etc.)
•
Check the cabling (especially for: crushing, abrasion, cuts, visible insulation of the inner
conductor, visible metallic veins, kinks, lumpiness, color changes of the outer sleeve, brittle
spots)
•
Electric leads to be securely placed to avoid shearing, crushing and other mechanical stresses
and strains.
•
For the charger of the scooter measure the resistance of the protective braid (O) according to
VDE 0702-1
•
For the charger of the scooter measure the residual diversion current (A) according to VDE
0702-1
•
For the charger of the scooter measure insulation resistance (MO) according to VDE 0702-1
•
Check the functioning of the drives (during a test drive noises, speed, free running, etc.), if
necessary: Measure the performance, first with no load and then with the nominal load, to
check for wear and tear of the motors by comparing the values of the electric current with the
values when the scooter was delivered.
•
Check the condition of the batteries, covers and tubes.
•
Completeness of the delivery condition, instruction manual available?
Checking measurements may only be carried out by skilled persons trained on the scooter. Only an
electrician is able to release the scooter for use after performing measurements or servicing.
The service must only be confirmed in the maintenance plan if a minimum of all the above-mentioned
aspects have been checked.