Vermeiren Carpo 4 deluxe, Инструкция по эксплуатации

Страница: 19 / 40

Carpo 4 Deluxe
2012-04
Page 17
2.14 Charging the batteries
L
WARNING:
Risk of injury - Take out the key before you start charging.
L
WARNING:
Risk of fire - Keep away from flammable objects while charging as it may
lead to fire of battery.
L
WARNING:
Risk of electrical shock - Never connect or disconnect the plug or cable with
wet hands while charging.
Fully recharge your new battery before its first time use.
The light emitting diode (LEDs) in the steering unit indicates the remaining capacity of your batteries. If
the battery charger is turned on and no LED's are lit, check the fuse. If the red LED does not illuminate
the charger is defective, consult your specialist dealer.
Recharge the batteries on a daily basis and in a well-ventilated space, not directly exposed to sunlight.
Do not charge in surroundings where it is humid or under rainfall and morning dews. If you do not do
that and you keep on driving, the output of your scooter will drop very significantly (uphills, bends, dim
headlights). If you ignore these signals too, your scooter will turn off. You should now immediately
recharge your scooter with the accompanying battery charger. Be sure that you charge the battery
fully every time.
After charging or replacing a new battery, drive the vehicle for 2-3 minutes to make sure the battery
capacity is sufficient.
The battery capacity will vary by how you drive with your scooter (repeated starting, stopping,
climbing, rough terrain) and will consume the capacity more quickly. In wintertime, the battery may
respond more slowly and the battery range may be reduced.
Kindly also observe the accompanying operating instructions.
Primary 230V ~ / 50-60 Hz / 270 W max.
Secondary 24 V / 8A max.
Model Impulse S
Max. battery cap. 85 Ah
Charging Charge 80% cap. within 8 hrs
1. Turn the key to OFF and take it out.
2. Open the protecting flap of the charging socket.
3. Insert the plug of the charger into the charging socket of the
scooter .
4. Insert the mains plug of the charger into the power socket.
Switch the charger to ON (a few models have no ON/OFF
switch; with these the loading device starts operating
automatically when you insert the mains cable).
5. The charger now starts to charge and the LED (red and
orange) will be lit, which indicates that it is busy charging.
While charging your scooter it is not possible to run, drive
your scooter because the immovable function will be
activated.
6. Once the charging process is complete, the LED (orange)
turns green, thereby indicating that loading is complete. The
charging duration is about 6 hours. To ensure optimum
performance a 10-hour charge is recommended. But we do
not recommend a charging more than 24 consecutive hours.
7. First switch off the charger (if there is no ON/OFF switch,
pull out the mains plug).
8. Pull out the charger out the power socket.
9. Pull out the charger plug from the charging socket of the
scooter. Your scooter is again ready for use.
1