12
Quick Install Harness Installation
1.
Open box. Make sure all necessary components
are inside for proper install. Harnesses are
shipped separately and cannot be returned once
opened.
2.
Locate the DLC or OBD-II port for installation and
plug-in the DLC side of the Quick Install Harness, then plug-in the vehicle harness side of the Quick Install
Harness into the Networkfleet device.
3.
Verify successful installation with LED Indicator Lights sequence on side of unit.
a.
Start the vehicle’s engine. All lights (Red, Yellow, and Green) on the device should turn on solid for 15
seconds and then begin blinking rapidly (twice a second).
b.
The device is operating normally when the rapid blinking ceases and the Green and Yellow lights begin
to blink in a slow pattern (ON for 5 seconds and OFF for 1 second).
c.
The vehicle must be idled or driven for at least 15 minutes to reach normal operating mode and ensure
activation is complete.
d.
Call Customer Care at 866.227.7323 (option 5) to verify successful install and to acquire a case number.
4.
Completing Installation: Before securing the device under the dashboard, make sure that you have recorded the
full VIN (17 digits), hardware serial number (10 digits) and odometer reading on the registration form. Also verify
that you have checked the light indicators.
5.
Securing the Device: Use the enclosed long zip ties to fasten the hardware securely to a stable bracket or wire
bundle high under dash. Unit must be facing up (Networkfleet logo side) and with no metal obstructions above it
that would block the signal; check that the green LED is blinking in a slow pattern, which verifies that the unit is
getting GPS data.
6.
After installation, provide the registration form to the fleet manager for delivery to Networkfleet or if you are a
Networkfleet Certified Installer, please fax to 866.616.2131 or email to
