Verity Medical NeuroTrac IFC Rehab, Руководство по эксплуатации

Страница: 39 / 44

NeuroTrac™ IFC Rehab Operation Manual
39
10. Troubleshooting
Problem Possible cause Remedy
The display does not
come on and there is
no signal from the unit
Batteries discharged Replace batteries
Batteries were incor�
rectly positioned
Remove battery and replace
correctly
The unit turns on , but
does not carry out com�
mands
Lead wires not fully in�
serted
Remove plug , reinsert
Broken Lead wires Replace lead wires
Battery symbol flashing The battery voltage is
low
Replace the battery
Current drops to 0 mA
and readjustment to
higher than 10mA level
is not possible.
Open circuit detected:
Broken lead wire.
Broken electrode wire.
Poor skin/electrode con�
tact.
Replace broken accessory
If the closed circuit is broken,
for example if a Lead wire is
broken, the current to both
channels (TENS/NMS or IFC)
switches off automatically.
Excessive resistance results
in amplitude being dropped
to zero and displayed as 0
mA (flashing). Correct the
problem by making sure the
connection is re�established
(new wires, new electrodes,
check on skin connection)
and restart the programme
by setting the amplitude.
If you cannot find the answer from the above table, please visit our website
www.veritymedical.co.uk, select CONTACT US and then select KNOWLEDGE BASE
to get the most up to date list of possible solutions.
If you experience a continuous problem and are thinking of returning the product
or getting it fixed, please read the warranty section on page 40:
� Contact your Distributor who may be able to guide you through any issues.
� You will need to obtain notice from the Distributor from whom you purchased the
unit before returning it to them for replacement or repair (sometimes the returned
products are not faulty and there is another reason for it not working, in this situa�
tion you might be charged for postage and/or product examination).