Next set of Loudspeakers installed
Using wire rope to
adjust the
appropriate
horizontal angle
The importance of assemble
flying frame at the bottom
①
Special design flying frame for
Horizontal radiation angle
.
it must be use
wire rope to keep it in right position but
not allow to tighten cabinets directly by
wire rope
②
It can use as flying frame when it work
in large angle
Fixed the front attachment
points of first group cabinet
and the second group cabinet
It must to use auxiliary rope
to share the weight of cables
When cabinets suspended
in high sky
The first group cabinet is
lower it will make one side
of second group cabinet
off ground
.
If the angle is
large, you can use the
hand to pull up rear
connecting rod to make it
easier to connect
Pull up the bottom
part of the VT
Lift the cabinets to
predetermined height
Assemble the flying frame on the
last cabinet
。
it must be use wire
rope to keep it in right position but
not allow to tighten cabinets
directly by wire rope
INSTALLATION
INSTALLATION
Hanging installation:
①
Move one set cabinets to theright place
and remove top coverof the VT.
②
Fixed the Flying Frame and Extension
bar to the cabinet and preset the angle
of each cabinet.
③
Suspension the electric hoist (Select
the suspension position
.
It very important)
This pointdetermines the final angle of the
entire linear array. It is generally
recommended to choose betweenthe two
holes in the middle of the extension bar.
It can also use twoshackles to hang two
adjacent holeswhich makes it easier to
adjust thehorizontal angle.
④
Lift the electric hoist make thecabinets
off the ground and remove the bottom
part of the VT.
⑤
Lift the first cabinets group and move
the second cabinets group below the
first array cluster
，
and then carefully
lower the suspended cabinets group
when front attachment points come
together and use the magnet pin locked it.
⑥
After front attachment points is locked
carefully lower suspended cabinets
group until the rear attachmentpoints
come together and use themagnet pin
locked it.
Suspension skill:
It can use hand to pull up the bottompart
of the VT and make the secondcabinets
group cabinet rear attachmentpoints
close the rear attachment pointsof the
first cabinets group cabinet
,
it need be
careful about the safely when pull up
the second cabinets group cabinet.
Move the cabinet group
to a hanging position
Choosing the right lifting point to
raise the cabinet group through
electric hoist
Remove the bottom
part of the VT
Installation flying frame
and extension rod
