18
Inserting the Bobbin
A
A
B
C
B
A
A
B
C
B
A
A
B
C
B
A
A
B
C
B
Inserting the bobbin
When inserting or removing the bobbin, the needle
must be fully raised, therefore press the button „Needle
up / down“. Raise also the presser foot. Then turn off the
machine.
ATTENTION:
Turn power switch to off („O“) before inserting
or removing the bobbin.
1. Disengage the lever by pressing the lever to the
right (arrow) and remove the transparent cover
plate above the bobbin.
2. Insert the bobbin in the bobbin case with the thread
running in a counterclockwise direction (arrow).
3. Pull the thread through the slit (A).
4. With a finger held gently on top of the bobbin. Draw
the thread at the arrow markings into the stitch
plate thread guide from (A) to (B).
5. Pull the thread at the arrow markings into the stitch
plate thread guide from (B) to (C).
To cut off excess thread pull thread back over the
cutting off blade at point (C).
6. Close the bobbin cover plate. First insert cover
plate on the left side, then press down right till it
engages.
1
2
3
4
5
6
