24
Cleaning or replacing the motor filter
The motor filter ensures no large dust particles can enter the engine. Clean the motor filter
every six months.
1. Grab the handle of the dust collector and press the button [b] to
release the dust collector. Lift the dust collector and set it aside.
2. Take out the motor filter [f] with your thumb and index finger from the
air inlet of the vacuum cleaner.
3. Clean the motor filter [f] under lukewarm water and let it air dry
completely. Do not use any cleaning agents or brushes.
4. Place the dry motor filter back in the air inlet.
5. Place the dust collector back on the vacuum cleaner. You will hear a
click when it is placed correctly.
Cleaning the cyclone system and the dust collector
When the dust collector and the cyclone system are very dirty, they can be cleaned under
lukewarm water.
1. Follow step 1, 2 and 3 of chapter Cleaning the cyclone filter.
2. Lift the cyclone system [g] out of the dust collector.
3. The dust collector [2] and the cyclone system [g] can be cleaned under
lukewarm water. Use a soft brush or sponge to remove tough dirt.
4. Dry the parts thoroughly and let them air dry at least for 24 hours to
ensure there is no more moist in the inside of the parts. Attention: using
the vacuum cleaner with damp parts can cause damage to the engine.
5. Place the cyclone system back into the dust collector.
Make sure the
tab at the top fits in the notch of the dust collector.
6. Press the cyclone filter back in the dust collector.
7. Close the lid of the dust collector. You will hear a click when it is closed correctly.
8. Place the dust collector back on the vacuum cleaner. You will hear a click when it is placed
correctly.
Cleaning or replacing the HEPA filter
The HEPA filter cleans the air one last time before it leaves the vacuum
cleaner. Clean the HEPA filter at least once per six months or when it
is very dirty. Replace a damaged HEPA filter with a new original HEPA
filter.
•
Open the grid [h] that covers the HEPA filter by pushing the clip.
•
Pull the clip back and take out the HEPA filter [i].
•
Rinse the HEPA filter under lukewarm water and let it air dry
completely. Do not use any cleaning agents or brushes.
•
Put the HEPA filter back into place, when dry, or replace it by a new
one.
• Replace the grid. Make sure that the grid is properly placed.
f
g
2
i
h