Verilux Rise&Shine VA06 Serenity series, Руководство пользователя

Страница: 14 / 16

14
Using the Snooze Feature
Sound Light
Timing Responses Responses
If you pr
ess
SNOOZE
after the wake-up light
goes on (15 or 30 minutes befor
e the wake-up
time, depending on what you’ve pr
ogrammed)
but befor
e the wake-up audio starts (five
minutes befor
e the wake-up time you have pr
ogrammed):
immediately
stays off goes off
five minutes later stays off starts at a low level and
begins a 15-minute cycle
during which it builds in
intensity until it reaches the
maximum brightness you
have programmed
five minutes before the
programmed wake-up
time
starts at low volume and
builds progressively to the
wake-up level you have
programmed
continues 15-minute cycle
at wake-up time at full volume you have
programmed. (Will play for
one hour or until you turn it
off, whichever comes first.)
continues 15-minute cycle
20 minutes after you
pressed SNOOZE
continues to play at
full volume you have
programmed (unless you've
turned it off).
reaches maximum intensity
you have programmed
If you pr
ess
SNOOZE
five minutes or
less earlier than the alarm time you
have pr
ogrammed:
immediately
goes off goes off
five minutes later
begins at low volume starts at a low level and
begins a 15-minute cycle
during which it builds in
intensity until it reaches the
maximum brightness you
have programmed
10 minutes later has increased in intensity
and is now at the
full volume you have
programmed
continues 15-minute cycle
20 minutes later continues to play at
full volume you have
programmed for one hour
or until you tune it off,
whichever comes first
reaches maximum intensity
you have programmed
The SNOOZE feature behaves differently, depending on when in the alarm cycle you
press the
SNOOZE
button on top of the Rise & Shine:
Problem Solution
The device is not working correctly. Unplug from power, wait 30 seconds, then plug in again. If this is unsuccessful, try
resetting the unit. See instructions on page 10.
NOTE: Resetting the unit will require you to reprogram it as well.
When I program the alarm or sleep
cycle using the back-up batteries
as the power source and later use
the AC adapter to plug the unit into
a wall outlet, the alarm and sleep
cycles do not function properly.
Install new or fully charged batteries and reprogram the alarm and sleep cycles, or
program them with the Rise & Shine plugged into the wall outlet.
Troubleshooting