D
EVICE
S
ETUP
Using the Smart Card Reader
24
T650T I
NSTALLATION
G
UIDE
To Install a Paper Roll
1
Hold both sides of the paper door, which is on the upper corner of the device
and open the paper door by pulling outside (See below Figure 11).
2
Remove any partial roll of paper in the tray.
Figure 12
Steps to Install a Paper Roll in T650T
3
Loosen the glued leading edge of the new paper roll or remove the protective
strip. Unwind the paper roll past any glue residue.
4
Hold the roll so that paper feeds from the top of the roll.
5
Pull the paper past the printer door.
6
Align the printer paper to the tabs to the paper guides and hold the paper up
when closing the door.
7
With the printer paper extending outside, close the printer door by swinging
upward until the door clicks shut, allowing the printer paper to extend outside
the printer door.
Using the Smart
Card Reader
Insert the smart card to proceed with the EMV transaction. EMV supports credit
card and debit card transactions.
To Conduct a Smart
Card Transaction
1
Position the smart card with the contacts facing upward (see illustration
below).
B
C
A