Veria 8277B-W, Руководство пользователя

Страница: 17 / 22

Note: If
the button address is not set in the same way as the address of the target
monitor, the monitor can monitor the input station, but the input station cannot call the monitor.
28. Private equipment.
If this feature is enabled, the input station can be set up as a private device for only one family. A private
entry station can only be monitored by this family and can only be called to this family.
29. Monitor (monitor).
If this feature is enabled, the input station can be monitored by internal monitors.
If you disable this feature, the monitors will not monitor the input station.
30. Unlock with monitor.
If this feature is enabled, you can unlock the door or gateway in the tracking state by pressing the "Unlock"
icon. If you disable this feature, you can unlock the door or gateway only when you make a call by pressing
the unlock icon.
31. State of the door lock.
If you connect a door lock to the system, you must enable this function, set
"Unlock time " and by lock type "Unlock signal type" (Normally open or Normally closed).
32. The state of the gate lock.
If you connect a gateway lock to the system, you must enable this feature, set
"Unlock time " and by lock type "Unlock signal type"
(Normally open or Normally closed).
33. Type of outgoing button.
Set the target of the outbound button control on the door or gateway, depending on the actual
installation. Press the exit button to open the door/gate lock.
34. Status assigned from the washing machine.
Related information aboutthe device
will not be
displayed until it is connected from the
device to the system.
35. Status of the elevator controller.
You can enable/disable the elevator control function.
Note: This feature only works if an elevator control module is installed on the system.
36. Setting the security parameters of the input
unit (depending on the type).
37. Tampéru,
(protective contact when the cover is opened
illegally) after
activation of this function, a security
contact will be activated in the input station , tamp
é
r and if someone tampers with the entrance
station, an alarm
will be triggered. The room number must also be set to receive the tampee alarm.
38. Check the condition of the door.
If this function is enabled, the system checks the door status after the longest opening time
Door. Set "Magnetic Contact Type" according to door lock type
(Normally open or Normally closed). Set "Longest opening time". Once the door is open, the entrance
station will check their status for the longest opening time set.
If the door is not closed after the longest opening time set, a beep will sound from the entrance station.
39. Adjust the volume of the bell speaker.
You can adjust the volume from 10% to 100% as needed.