Rev 1.1 Cod. 00.009.124
28
Manual dosing:
A) Deactive cycle
B) Active cycle
1.
t = t
1
:
Istant of switching on of
the pump or istant of receiving
the enable signal
2.
t = t
2
:
Istant of switching off of
the pump or interruption of the
enable signal
QUANTITY DOSING
When the pump is switched on or the Enable signal (Optional) is received, the pump doses the set quantity of product
(
mL Dos
) with the selected % flowrate (
%Flowrate
).
NB: it is important to define the flowrate of the pump in the
Calibration
menu.
EXAMPLE OF MODIFICATION OF mL Dos.:
In the menu
Dosing
, select by the cursor "
Quantity
"
and press
ENTER
.
In the figure on the left you can see the factory
parameters.
Use the ▼▲ buttons to select the parameter to be
changed and press
ENTER
.
Use the ▼▲ buttons to select the desired value and
press
ENTER
whenever necessary to confirm the
change.
If you want to esc programming and return to
measurement, press the
ESC
button for 3 seconds.
PARAMETERS:
mL Dos:
quantity of chemical to be dosed
%Flowrate:
dosing flowrate
TIMER DOS DOSING
When the pump is switched on or the Enable signal (Optional) is received, the pump doses with an hourly rate, the total
quantity of product (
mL Tot
) over the total hours set (
Total Hours
). At each hour it will dose the quantity result from the
division mL Tot ÷ Total hours (any rest is not dosed). You can choose which days of the week perform the dosing.
The count is reset at midnight every day.
The pump has a clock to set in
Set
up
, page 21.
NB: it is important to define the flowrate of the pump in the
Calibration
menu.
EXAMPLE OF MODIFICATION OF mL Tot.:
In the menu
Dosing
, select by the cursor "
Timer
Dos
" and press
ENTER
.
In the figure on the left you can see the factory
parameters.
Use the ▼▲ buttons to select the parameter to be
changed and press
ENTER
.
Use the ▼▲ buttons to select the desired value and
press
ENTER
whenever necessary to confirm the
change.
If you want to esc programming and return to
measurement, press the
ESC
button for 3 seconds.
