12908357-180528EN(3)
Subject to misprints, errors and technical modifications.
Installation manual Sun awning V255 Salou
1.1 Marking the holes
For the installation of the awning, the two wall supports (A) need to be level horizontal and vertical. See figure 1.1
and 1.2. The wall supports need to be installation in the same line on the wall. If the wall supports are not in the same
line (with an uneven position of the arms as a result) the awning will not function correctly.
Mark the drill holes of the wall supports (A) carefully on the
wall according to size X and size Y in figure 1.2.
Make sure that the upper installation holes are in the
middle of the stone.
If necessary, use an alignment string.
fig. 1.2 Placing the wall supports
4
fig. 1.1 Wall support sun awning
1. Installation on the wall
W = Width of the awning
Y = Window frame height plus minimal 30 cm
A = Wall supports
A
A
1.2 Drilling the holes
Drill the installation holes. We advise to use a 14 mm stone drill if you need to drill in a cement or stone wall. Use
matching plugs and nuts of high quality. Install the awning on the wall and fasten the nuts in the wall supports (A)
tightly. Use a clack with lengthening piece.
1.3 Drilling the control hole
Do you have wall control and do you want to connect it on the inside? Measure the location of the control hole carefully.
The location depends on your personal preference and situation. Drill with a 10 mm drill to the inside. Hold a shelf on the
inside of the wall to prevent damages to the wall when drilling through.
W
A
A
Y
