E - 6
TURNING ON THE UNIT FOR THE FIRST TIME
The first time you turn on the unit, the unit will enter SETUP mode. You can easily follow the
prompt message on the screen to complete basic TV settings.
1. Press the
/ button to select Yes.
Press the
ENTER
button to proceed
with the initial setup.
2. Use the / button to select Antenna,
then press the
/ button to select Air
or CATV.
3. Use the / button to select Auto Scan, then press the button to enter auto scan
menu. Use the / button to select Start to Scan, then press the button to begin
scanning (If you selected CATV on Step 2, you need to select Cable System before Start
to Scan). The system will automatically start to scan and preset all available TV channels.
4. After scanning has finished, the system will return to the first TV channel scanned.
Make sure the RF aerial has been
connected properly to the
TV ANTENNA
input jack on the
rear of the system.
PICTURE
AUDIO
TIME
SET UP PARENTAL
TV
TV
Antenna
Auto Scan
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
DTV Signal
CATV
UP/DOWN
ADJUST "MENU":EXIT
PICTURE
AUDIO
TIME
SET UP PARENTAL
TV
TV
Cable System
Start to Scan
AUTO
UP/DOWN
ADJUST "MENU":EXIT
PICTURE
AUDIO
TIME
SET UP PARENTAL
TV
TV
RF CH
Found
16
0
:
:
PRESS <MENU> TO EXIT AUTO SCAN
When you turn on your television set
for the first time, be sure to place it on
a solid stable surface. To avoid danger,
do not expose the TV to water, or a
heat source (e.g. lamp, candle, radiator).
Do not obstruct the ventilation grid at
the rear and be sure to leave sufficient
gaps around the unit as shown.
:SELECT
Proceed with auto scan ?
No
Yes
"ENTER":CONFIRM
2 ½”
2 ½”
8
7
QUICK INSTALLATION
