Venture Products VENTRAC KX522, Руководство владельца/оператора и список запчастей

Страница: 11 / 23

Gear box Drive, Au ger Drive, & Top Au ger Drive Belt Re place ment
1. Re move the belt drive cover.
2. Re lease the belt ten sion spring and re move the old belt(s).
3. In stall the new belt(s) and ap ply the belt ten sion spring.
4. Re in stall the belt drive cover.
Spring Ten sion Ad just ment
The spring tension is adjustable for all the belts. This is to allow some belt slippage to protect the
gearbox and drive components in the event an immovable object stops the auger or fan. At the
factory, the spring is installed with a limited amount of tension. If required, the spring tension can be
increased.
Chute Ad just ment
The discharge deflector can be hand adjusted to several different settings. Release the chute
adjustment link by pulling to the side and move the deflector to the desired angle. Re-engage the link.
With an optional electric actuator installed, the discharge deflector can be adjusted with a switch on
the dash of the tractor.
Skid Shoe Ad just ment
Skid shoes are provided to keep the cutting edge off
the surface to be cleaned, especially when clearing
snow on gravel drives and roadways. To adjust the
skid shoes, park the tractor and snow blower on a
level surface. Raise the blower and set blocks of the
desired height under the cutting edge. (See Fig ure 3)
Lower the snow blower until it is resting on the
blocks. Loosen the skid shoe mounting bolts and
slide the skid shoes until they touch the ground.
Re-tighten the mounting bolts. Both the right and the
left skid shoes should be set at the same height.
Au ger Hous ing Wear Edge Ad just ment
After the skid shoes are adjusted to the correct
height, park the tractor and snow blower on a level surface. Lower the snow blower until the skid
shoes are resting on the ground. Set the auger housing wear edges approximately 1/4" above the
ground.
Ver ti cal Cut ting Edge Ad just ment
The vertical cutting edges can be adjusted to provide either a 52" or 54" cutting width. If the shorter
flanges (2-7/8 - 3") are bolted to the snow blower, the cutting width is 52". If the longer flanges are
bolted to the snow blower, the cutting width is 54". To switch from one cutting width to the other,
rotate the cutting edges 180 degrees. Do not switch the cutting edges to opposite sides of the snow
blower. The left cutting edge has 15 degrees greater bend than the right.
MAIN TE NANCE/AD JUST MENTS
D-2
Fig ure 3