Vents DVUE 300 HB, Руководство пользователя

Страница: 12 / 24

12
DVUT/DVUE HB(E/E2) EC
www.ventilation-system.com
MOUNTING OF SENSORS FOR UNITS WITH A14 AUTOMATION (NOT INCLUDED IN THE DELIVERY SET)
The humidity sensor must be attached inside of the extract air duct.
Attach the sensor to the insert. Open the unit, remove the upper part of the protective casing and install the insert with the sensor on
the bracket located on the wall of the exhaust duct. Connect the sensor connector to the connector with the cable from the control unit
(installed by the manufacturer).
After connecting the humidity sensor, it is necessary to change the control configuration in the controller. Contact the product Seller for
doing that.
The CO
2
sensor must be installed in the exhaust air duct upstream of the heat exchanger. Open the unit, remove the upper part of the
protective cover. Using a screwdriver remove the screw on the bracket holding the insert. Then use a small screwdriver to disconnect
the connector. Disassemble the CO
2
sensor in accordance with the instructions supplied with it and connect it in accordance with the
provided diagram. Reassemble the sensor in the reverse order and install it on the bracket inside the unit.
Update the control configuration after connection of the humidity sensor. Contact the product Seller for doing that.
1
3
2
CO
2
sensor connection
+U 24 V AC / DC
GND
0-10 VDC
From the unit
controller