Ventrac KX523, Руководство оператора

Страница: 21 / 49

SERVICE
Service - 21
Lubrication Locations
Lubrication is required at the following locations using
a lithium complex NLGI #2 grease. Refer to the main-
tenance schedule for service intervals. Use only one
pump of grease.
Main Auger Bearings
Deep Snow Top Auger Bearings (if equipped)
Fan Shaft Bearings
Drive Shaft Bearings
Discharge Chute Rotation Chain
Gearbox
The gearbox uses 80-90 weight gear oil. Gearbox oil
level should be maintained at approximately half full.
Refer to maintenance schedule for service intervals.
Storage
Preparing the Snow Blower for Storage
1. Clean the snow blower.
2.
Attention
To maintain the finish of the power unit and attach -
ment, thoroughly wash the equipment to remove any
corrosive agents (e.g., salt). Failure to clean the equip-
ment may result in corrosion of (including but not lim-
ited to) steel, aluminum, and electrical components.
Inspect for loose or missing hardware, damaged
components, or signs of wear.
3. Inspect safety decals, Replace any safety decals
that are faded, illegible, or missing.
4. Inspect hydraulic hoses and fittings to ensure
tight, leak free connections. Repair or replace
any damaged or worn components.
5. Inspect belts for signs of damage or wear and
replace as required.
6. Inspect cutting edge and skid shoes for wear
and service as required.
7. Service all lubrication points and inspect gearbox
oil level.
8. Wipe off all excess grease or oil.
Removing the Snow Blower from Storage
I
nspect, clean, and prepare snow blower for use .